The TSS MG42 / MG3 / M53 Barrel Stop is a reproduction brought to market to fill the need for damaged or missing barrel stops not currently available on the market. These barrel stops have been faithfully reproduced to meet the critical barrel mating geometry and fitment within your shroud, though they take a slightly different form factor for manufacturability. These are perfect for real MG42 receiver, Yugo receivers or BRP aftermarket shrouds.
Specifications:
4140 Prehardened Steel construction
Black Oxide Finish
Made to German MG42 Barrel Stop Specs
Will require Custom fitting and Rivet hole Drilling
These barrel stops have prebent wings that engage in the barrel shroud windows, but will require you to drill the 3 rivet hole locations, specific to your barrel shroud. You should expect manageable hand fitting to your specific shroud. Rivets not included, but can be sourced from BRP.
DISCLAIMER: Note there is nothing drop in about these barrel stops. Similar to all original barrel stops on the market, these will require varying amounts of hand fitting to fit your particular rifle. Rivet holes will need to be drilled and fine tuning to ensure smooth barrel travel may also be required. It is recommended to install the barrel stop before welding the barrel shroud and rear receiver segment together, particularly on BRP receivers. When installed to the shroud, introduce the barrel change door and hand fit clearance to the barrel door loop. These are sold as is and mimic the original functional design criteria as close as possible. Varying amounts of hand fitting will be required on a case by case basis and is required to ensure proper function of the MG42. TSS requires a qualified gunsmith to install this part and does not assume any liability for the use of this part.
